Altronix NetWay8M Guide d'installation Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
NetWay8M/NetWay16M - 9 -
Note: Port 80 is the default port used for web browsing. Because of this, in order to prevent the average user from host-
ing a web server, most ISPs BLOCK traffic using port 80 from reaching the average site. If you only plan to monitor your
NetWay8/NetWay16MonaLAN,youcanuseport80,anddon’thavetoconcernyourselfwithrouters.However,ifyou
desire remote access to your NetWay8M/NetWay16M, you MUST select functional ports and set up the port forwarding
in your router. Other ports, such as 8080 and 8000 are sometimes blocked by ISPs as well. What port(s) should be used?
There are 65,535 valid IP ports to choose from. These are broken down into three groups:
•WellKnownPorts0through1023
•RegisteredPorts1024through49151
•Dynamicand/orPrivatePorts49152through65535
So, rather than encounter a port conflict by choosing a port commonly used for another purpose (like port 25 for SMTP
mail or port 448 for secure sockets), choose an ‘unusual’ port number. For example, add 50,000 to your house number:
50,123 is less likely to lead to a port conflict. For a list of the known and registered ports,
see http://www.iana.org/assignments/port-numbers.
Reset Features:
Reset Password:
1. Set illuminated master power disconnect circuit breaker to the (OFF) position (Fig. 1g, pg. 3).
2. Set illuminated master power disconnect circuit breaker to the RESET (ON) position (Fig. 1g, pg. 3)
while depressing the [RESET button] on the front of the NetWayM (Fig. 1d, pg. 3).
3. NetWayM status LEDs will display a flashing pattern which indicates reset was successful (Fig. 1c, pg. 3).
Reset IP to Factory Settings:
1. During normal operation depress the [RESET button] on the front of the NetWayM for approximately
1 second (Fig. 1d, pg. 3).
2. NetWayM status LEDs will display a flashing pattern which indicates reset was successful (Fig. 1c, pg. 3).
3. Factorysettingsare:DHCPserverandtheIPaddressis[192.168.168.168].
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire