Altronix NetWay8M Guide d'installation télécharger pdf (Page 3)

NetWay8M/NetWay16M - 3 -

Fig. 1

1a OUT 1-8 (NetWay8M), OUT 1-16 (NetWay16M): Structured cable to PoE compliant cameras/edge devices.

1b IN 1-8 (NetWay8M), IN 1-16 (NetWay16M): Structured cable to ethernet switch or video server.

1c LED(s) 1-8 (NetWay8M), 1-16 (NetWay16M): Port status LEDs.

1d Reset: Restores unit to factory settings.

1e +---,PoEShutdown:Lowvoltagetriggerinput(see Technical Specifications pg. 5).

1f Ethernet: LAN or laptop connection enables NetWayM programming and status monitoring.

1g Illuminated master power disconnect circuit breaker (switch):

 • OFFpositionCircuitbreakertrippedSwitchnotilluminated.

 • RESET(ON)positionSwitchilluminated.

1h IEC320Connector:115VAC60Hz(groundedlinecordincluded).

AC POWER

NetWay8M & NetWay16M - Rear Panel

NetWay8M - Front Panel

NetWay16M - Front Panel

+ PoE --

SHUTDOWN

+ PoE --

SHUTDOWN

1e 1f

Note: All interconnected devices must be UL Listed.

7. Upon completion of wiring set illuminated master power disconnect circuit breaker to the RESET (ON) position (Fig. 1g, pg. 3).

8. Port status LEDs on the NetWayM will initialize when PoE devices are connected as follows:

- LED will illuminate when devices are IEEE 802.3af compliant.

- LED will blink once and illuminate when devices are IEEE802.3at compliant (PoE Plus).

9. To utilize the PoE shutdown feature it is necessary to do the following:

a. Connect a device that will provide a low voltage trigger input (see Technical Specifications pg. 5) to terminals

  marked[+---,PoEShutdown]ontheNetWayM(Fig. 1e, pg. 2). When voltage is applied, the PoE shutdown

  enabledPoEport(s)willdroptozerovolts.Removingthelowvoltagetriggerinputatthe[+---,PoEshutdown]

terminals will allow the PoE port(s) to operate normally and supply power to PoE compliant devices. Power will

reset in approximately 4 seconds. Although there is no output voltage to power PoE devices during shutdown, data

signals may still be present on the data pair lines of the structured cable.

b. Individual ports must be programmed utilizing the user interface (see User Interface and Programming, pgs. 6 & 7).

Port Status and LED Flash Codes:

Port Status Flash Codes Description

All Ports Off Sequential LED Port Scan No devices connected

Port Off OFF LED OFF

Port On ON LED ON

Class 4 detection Port Blinks 2 times Enables power to PoE devices.

Non-compliant Device 2Hz Will prevent port from turning on.

Port Overload Fault 5Hz Will prevent port from turning on.

4 Port Overload Grouped 5Hz

4 LEDs

Will prevent ports from turning on.

8 Port Overload Grouped 5Hz

LEDs 1-8 Power Supply Overload for ports 1-8.

LEDs 9-16 Power Supply Overload for ports 9-16.

1 2 3 4 5 6 7 8 ... 11 12

Commentaires sur ces manuels

Pas de commentaire

Altronix NetWay8M Guide d'installation Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Serveurs Altronix NetWay8M