Altronix NetWay8M Guide d'installation télécharger pdf (Page 11)

NetWay8M/NetWay16M - 11 -

Wall Mount Installation

1- Install mounting brackets (A) on the left and right side of rack chassis using

four (4) flat head screws (B) (included) (Fig. 8a).

2- Place unit at desired location and secure with mounting screws

(not included) (Fig. 8b).

Caution: It is necessary to

make sure mounting screws

are securely fastened to a

beam when installing the

unit vertically.

Mounting Options:

Fig. 7

Rack Mount Installation

1- Remove and discard factory installed screws from both sides of rack chassis (Fig. 7a).

2- Install mounting brackets (A) on the left and right side of rack chassis using the

four (4) flat head screws (B) (included) (Fig. 7b).

3- PlaceunitintodesiredEIA19”rackpositionandsecurewithmountingscrews(not included) (Fig. 7c).

Fig. 9

Fig. 8

Shelf Installation

1- Position and affix rubber pads (C) (included) at each

corner on the bottom of the unit (Fig. 9).

2- Place unit in desired location.

Mounting Hardware (Included):

Fig. 8b

Fig. 8a

Fig. 7b

Fig. 7a

Fig. 7c

Top Top Top

Front

Left

Front

Left

Front Left

Left Side

Rubber Pad

Two (2) mounting brackets

Six (6) flat head screws

for mounting brackets.

Four (4) rubber pads.

Remove

Dotted lines indicate studs

behind sheetrock.

1 2 ... 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Altronix NetWay8M Guide d'installation Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Serveurs Altronix NetWay8M