Altronix FireSwitch108 Data Sheet Manuel d'utilisateur télécharger pdf

Input:

• Powerinput:120VAC60Hz,4.8amp.

• Two(2)ClassAortwo(2)ClassBFACPinputs.

• Two(2)configurableinputstriggerviaClassAor

 ClassBFACPsignalcircuits(polarityreversal)or

 drycontacts.

Output:

• 24VDCvoltageregulatedpower-limitedNACoutputs.

• Outputpower:

 10ampmax.totalalarmcurrent.

 7ampmax.stand-bywithoutbatteryback-up.

 1ampwithbatteryback-upincluding

 dedicatedAux.output.

 For Canadian applications Stand-by with

battery backup is limited to 0.45 amp.

• 2.5ampmaxcurrentperoutput.

• One(1)auxiliaryoutputratedat1amp

 (regulated,batterybackedup).

 0.45 amp for Canadian applications.

• AnyNACcanbeconfiguredasanAux.outputwithor

 withoutbatteryback-up(specialapplicationonly).

 WhensetasAux.output,theoutputisnotsupervised.

• Programmablesupervisedindicatingcircuitoutputs:

 Eight(8)ClassBorFour(4)ClassA,

 oranycombinationofClassAandClassBcircuits.

• Thermalandshortcircuitprotectionwithautoreset.

Battery Backup:

• Built-inchargerforsealedleadacidorgeltypebatteries.

• Automaticswitchovertostand-bybatterywhen

 ACfails.

• Zerovoltagedropwhenswitchingoverto

 batterybackup.

Supervision:

• ACfailsupervision(form“C”contacts).

• Batteryfail&presencesupervision(form“C”contacts).

• Lowpowershutdown.ShutsdownDCoutputterminals

 ifbatteryvoltagedropsbelow70-75%for24Vunits.

 Preventsdeepbatterydischarge.

Special Features:

• ProgrammableLCDdisplayinterface.

• Ethernetportinterfaceforremoteprogrammability

 andmonitoring.

• 2-wirehorn/strobeSyncmodeallowsaudible

 notificationappliances(horns)tobesilenced

 whilevisualnotificationappliances(strobes)

 continuetooperate.

• TemporalCode3,SteadyMode,InputtoOutput

 FollowerMode(maintainssynchronizationof

 notificationappliancescircuit).

• Compatiblewith12VDCor24VDCfirepanels.

• Outputloopsupervisiondirectedtoinput1orinput2.

• CommontroubleDryN.C.outputforreporting

 troubletoremoteFACP.

• Groundfaultdetection-Groundfaultmaximumtest

 impedance1,000ohm.

• GroundfaultDryN.O.outputtoreportgroundfault

 toremoteFACP.

Electrical:

• Operatingtemperature:0ºCto49ºCambient.

• BTU/Hr.:122.84BTU/Hr.

• SystemACinputVArequirement:576VA.

Visual Indicators:

• LCDdisplay-Indicatestroublesandconditionsof

 operation.TroubleConditionMemoryfacilitates

 quickidentificationofanintermittent/fault

 (shortcircuit,openorground)whichhaspreviously

 occurredononeormoresignalingcircuitoutputs.

 LCDdisplayswhichoutputthefaulthasoccurredon.

Mechanical:

• EnclosureDimensions(HxWxDapprox.):

 15.5”(393.7mm)x12”(304.8mm)x4.5”(114.3mm)

 - Accommodatesuptotwo(2)12VDC/12AHbatteries.

• Productweight(approx.):12.4lbs.(5.62kg).

• Shippingweight(approx.):13.7lbs.(6.21kg).

Specifications

TheAltronixFireSwitch108isacosteffectivemanagedNACPowerExtender.Itinterfaces

with 12 or 24VDC Fire Alarm Control Panels (FACP) to provide Notification Appliance

Circuitexpansionsupport,foradditionalhorns/strobestoallowADAcompliancy.Italsopro-

videsauxiliarypowertosupportsystemaccessories.Itdeliverselectronicallyregulatedand

filtered24VDCpowertoClassBorClassANACloopcircuits.Additionally,aseparate1amp

auxiliaryoutputfor4-wiresmokedetectorsisavailable.Alarmcurrentcanbedividedbetween

theeight(8)outputsforpoweringNACdevices.Outputsareratedat2.5ampmax.,andcan

beindependentlyprogrammedforSteady,TemporalCode3orStrobeSynchronization.All

outputsmaybeprogrammedforInputtoOutputFollowerMode

(outputwillfollowinput.i.e.MarchTimeInput,MarchTime

Output).Innon-alarmconditionindependentloopsupervision

forClassAand/orClassBFACPNACcircuitsisprovided.Intheeventofalooptrouble,theFACPwillbenotified

viathesteeredinput(input1orinput2).Inaddition,therearecommontroubleoutputterminals[NC,C,NO]which

areusedtoindicategeneralloop/systemtrouble.Two(2)FACPsignalingoutputscanbeemployedanddirectedto

controlsupervisionandpowerdeliverytoanycombinationoftheeight(8)outputs.ItprovidesaprogrammableLCD

displayinterface,plusanethernetportinterfaceforremoteprogrammabilityandmonitoring.

FireSwitch108

Managed NAC Power Extender

Rev.DSFireSwitch108_02082013

FireSwitch108

Overview

1 2

Résumé du contenu

Page 1 - Managed NAC Power Extender

Input:• Powerinput:120VAC60Hz,4.8amp.• Two(2)ClassAortwo(2)ClassBFACPinputs.• Two(2)configurableinputstriggerviaClassAor Cl

Page 2 - Agency Approvals

Altronix Corp. - 140 58th Street, Brooklyn, NY 11220 • 718-567-8181 • 888-258-7669 • altronix.comEnclosure Dimensions (H x W x D) (approximate):15.5”

Commentaires sur ces manuels

Pas de commentaire

Altronix FireSwitch108 Data Sheet Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour les appareils électriques Altronix FireSwitch108 Data Sheet. Altronix FireSwitch108 Data Sheet User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour les appareils électriques Altronix FireSwitch108 Data Sheet